Sunscreen Blinds - Ultimate 10 Sunscreen Blind Range
Ultimate 10 - Charcoal (6617)

It’s something that we get asked how to do all the time, so you will be happy to know our easy-to-follow guide has all your bases covered. Here’s everything you need to know for our New Zealand windows.

• Reach for your metal tape measure - its the very best tool for the job.


• You only need to know the width and the drop (length) - its that easy.


• You will need to select between the three options for fitting...

1) Measuring for Inside Fitting Blinds

• Step 1: Measure the width of the inside of the frame; across the top, bottom and middle. Write down the smallest of the three measurements.


• Step 2: Measure the drop (length) of the inside of the frame across the left, middle and right. Write down the smallest of the three.


• Step 3: Check that you have enough clear space inside the window to mount the blind. you will need 60 mm for a single roller blind and 100 mm for a double roller blind.


• Step 4: When ordering your blind, select the “inside (Frame)” option.


• Step 5: When ordering your blind, select “front roll” option. This means that the fabric will roll off the front of the roll to avoid any latches, or other hardware inside the frame.

2) Measuring for Outside Fitting Blinds:

• Step 1: Measure the outside of your window recess from one side to the other. You should be starting and finishing where you want the outside edges of the brackets to be.


• Top Tip: For best results allow your blind to overlap the edges of the recess by at least 50 mm on each side. - ensuring that you have enough space to accommodate the suggested overlap.


• Step 2: Measure your recess from top to bottom, starting from where you want the brackets to be and ending where you want the bottom of the blind to be.


• Step 3: When ordering your blinds, select the “outside” fit option.


• Step 4: When ordering your blinds, select back roll. This means that the fabric will roll off the back of the roll to ensure the fabric stays close to the architrave for maximum privacy and light control.

3) Measuring for Blinds to be Mounted on an Architrave

• Step 1: Measure across from outside edge of architrave to outside edge of architrave. Again, you should be starting and finishing where you want the outside edge of the brackets to be this will be your width measurement


• Step 2: Measure from the top to the bottom of your archtrave, this will be where your blind brackets sits at the top and where the bottom of your blind finishes - this will be your height measurement.


• Step 3: When ordering your blinds select the “Architrave” fit option.


• Step 4: When ordering your blinds select the “back” roll option. This means the fabric will roll off the back of the roll to ensure the fabric stays close to the architrave for maximum privacy, light control and better insulation.

There are two ways your roller blinds may roll - either front roll or back roll.

Front Roll

Back Roll

This is quite a common problem. Your window will require two blinds. Please contact us or phone us on 0800 763 748 so we can discuss the best options with you.

Yes, it is possible to link blinds in the same window. Please see specific questions below and refer to our linked blind page.

Rods and Blinds are always happy to help you place your order over the phone, especially if you need some expert advice about the products before you buy. Just call us on 0800 763 748 and speak to one of our trained advisors

We accept all major credit cards, account to account, and direct credit.

Your curtains and roller blinds have been designed to be easy to install. They come with step by step instructions with clear photos of each step. Our instructions are backed up by our 0800 number and we are happy to help.